Deleted (code required build 509 compiler to operate correctly).
Attached File(s)
MT4 (offline) installation kit needed 10 replies
Know Yourself, Know Your Setup, by Boris Schlossberg 9 replies
Paying Yourself 7 replies
Customize Display with Color Kit 35 replies
Z-Score Kit 51 replies
DislikedHanover.........I thought that I had it. I was able to compile the indicator with zero errors however, I am not receiving the alerts. Again, what I am trying to accomplish to have the Stochastics indicator alert when it crosses and closes above the upper level i.e. 80 or crosses and closes below the lower level i.e. 20. This indicator attached is my best attempt showing zero errors.Ignored
QuoteDislikedIf you want the alerts to occur when the indy crosses a value (rather than its signal line), then simply replace the code in red typeface with the required value(s), e.g. 100 (for the crossover UP) and -100 (for the crossover DOWN)
DislikedHanover.........I thought that I had it. I was able to compile the indicator with zero errors however, I am not receiving the alerts. Again, what I am trying to accomplish to have the Stochastics indicator alert when it crosses and closes above the upper level i.e. 80 or crosses and closes below the lower level i.e. 20. This indicator attached is my best attempt showing zero errors.Ignored
DislikedDT5,
Try the attached. Should alert when the solid line crosses and closes above the upper level, and/or crosses and closes below the lower level.
To ensure that it doesn't alert until after the line has closed, set AlertCandle to 1.
I haven't tested it - will leave that to you. Please advise if there are problems.
I've added a note to post #1. Due to work commitments, this is the last request that I can help with in this thread.
DavidIgnored
DislikedThank you David for those great and clear instructions!
But I have a question hopefully you can answered it also. Can we in some easy way also great alerts that uses for example 3 different indicators and the alert, arrow or line appears only when all the conditions are met?
Regards
KristjanIgnored
DislikedKristjan,
From the info you've given, and assuming I understand correctly, I'd guess that this lies outside the scope of this toolkit. If the 3 indicators are all different MQ4 files, then the alerting indicator would need to call iCustom() (or use some other means) to obtain the values of at least 2 of the indicators. However, the concepts used in the toolkit could likely be extended to achieve what you're asking; MQL4 is a versatile programming language, virtually anything is possible.
As I've indicated, I'm unable to undertake complex...Ignored
Dislikedhanover, i want the chart to show an arrow (below/above the alert candle)when signal is produced..how can i make that..can u pls give the code for that..
thank youIgnored